Baseball drill

Catcher throwdown footwork line drill

A line of tape or chalk on the ground just in front of the catcher's stance shows where the first step should land on a throw to second, and the catcher works the footwork off short tosses until it lands there every time. It trains short, direct footwork that gains ground toward the base.

A youth baseball catcher in full gear stepping sideways by a strip of white tape on the dirt, throwing arm cocked by the ear, as a coach watches
Video by Dominate The Diamond on YouTube. The write-up below is ours.

At a glance

Sport
Baseball and Softball
Skill
Catchers
Ages
10U to High school
Players
2 (a catcher and a feeder)
Time
About 12 minutes
Level
Intermediate
Equipment
Athletic tape or chalk, Catcher's gear and mitt, A bucket of balls, An empty bucket or a cone to stand in for a right-handed batter (optional)
Indoors
Yes

Catchers who throw late often have plenty of arm. What they lack is direction: the first step goes sideways, or too far, or not at all, and the throw starts from a bad spot. A line on the ground fixes that faster than any amount of talk, because after every rep the catcher can look down and see where the foot landed.

The video's line marks a short, direct first step toward second. The drill starts with barehanded catches of short tosses so the catcher can focus on the feet, then goes to the mitt and full throws. A bucket in the right-handed batter's box reminds the catcher that the footwork has to work with a hitter standing there.

Setup

  • Put a strip of tape or a chalk line on the ground a short step in front of where the catcher's feet are in the stance, running across the plate.
  • The catcher sets up behind the plate in the runners-on stance.
  • The feeder stands 15 to 20 feet in front with a bucket of balls. Put an empty bucket or cone in the right-handed batter's box if you want a stand-in hitter.

How to run it

  1. Start barehanded. The feeder flips a firm toss at chest height.
  2. The catcher catches it and brings it to the middle of the chest for the exchange.
  3. As the hands come together, the catcher takes a short step with the right foot (left foot for a left-handed thrower) so it lands on the line, pointing toward second.
  4. The other foot drives toward second as the hands break into the throwing position. The catcher holds the finish and looks down to check where the first foot landed.
  5. Once the steps land on the line every time, put the mitt back on and finish each rep with a full throw to second.

Coaching points

  • The first step is short and quick. A long first step slows the arm.
  • Keep the exchange tight at the chest while the feet move.
  • Stay low through the footwork so the legs drive the throw.
  • Move in a straight line toward second, not out toward the batter's box.

Common mistakes

  • Stepping well past the line, an overstride that leaves the arm behind.
  • Landing behind the line and gaining no ground at all.
  • Swinging the foot wide toward the batter's box instead of stepping straight.

Printable drill card

Take this drill to the field: the setup, steps, coaching points and equipment on one card, with the video's address to find it again. Free, no account needed.

Print the drill card

Smaller: half page or quarter page (PDF).

By age

10U

Do it barehanded with soft balls and no throw, until the steps land on the line. Short-distance throws only after that.

12U and 14U

Run both halves, barehanded then with the mitt, and finish with throws to a fielder at second.

High school

Add the stand-in batter, pitches to different locations, and a stopwatch on the full throws.

Next: Free defensive lineup generator.

Frequently Asked Questions

What footwork should a catcher use to throw to second?

Most coaches teach a short, quick step with the throwing-side foot toward second, then a drive step with the other foot as the hands break. The point is to gain a little ground in a straight line, not to stand up or step sideways.

More drills

Start free. Upgrade when your season needs it.

The free plan includes one team and one of each document type, with no license fee and no credit card. Paid plans start at $2.50 a month billed annually, cancel anytime.

See Pricing

No credit card required. Free plan available.