Softball drill

Paddle framing drill

A catcher wears a flat paddle on the glove hand and, instead of catching, taps the outside edge of tosses at the borders of the zone so they bounce back toward the middle. It teaches the small, firm hand movement behind good pitch framing.

A youth softball catcher in full gear crouched behind home plate wearing a flat training paddle instead of a mitt as a kneeling coach tosses a ball
Video by Championship Productions on YouTube. The write-up below is ours.

At a glance

Sport
Baseball and Softball
Skill
Catchers
Ages
12U to High school
Players
2 (a catcher and a feeder)
Time
About 10 minutes
Level
Intermediate
Equipment
A flat training paddle or pancake glove, A bucket of balls (softer balls for younger catchers), Helmet or mask and shin guards, Home plate (optional)
Indoors
Yes

Framing is not yanking a ball back into the zone after it lands. It is getting the glove to the outside of the ball and holding it there, so a pitch on the edge looks like the strike it is. That starts with where the catcher's hand meets the ball, and a full mitt hides it.

A flat paddle makes it obvious. With no pocket to catch the ball, the catcher has to meet it on its outside edge, and the ball's rebound tells them whether they did. If it bounces back toward the middle of the plate, the contact was right; if it kicks away, the hand got to the wrong side. It is a short, quick drill that fits well before a bullpen session.

Setup

  • The catcher sets up in a receiving stance behind the plate with the paddle on the glove hand, wearing at least a mask or helmet and shin guards.
  • The feeder kneels about 8 to 10 feet in front with a bucket of balls.
  • A plate on the ground helps both of them see where the edges of the zone are.

How to run it

  1. The catcher shows a low target with the paddle.
  2. The feeder tosses firm underhand balls to the borders of the zone: in, away, up and down.
  3. The catcher meets each ball with the paddle on the outside edge of the ball, so it bounces back toward the middle of the plate.
  4. Start slow, one location at a time, then let the feeder mix the locations and pick up the pace.
  5. Rotate after a set of 15 to 20 good taps, then catch a few with the regular mitt to carry the feel over.

Coaching points

  • The contact point is the outside of the ball, the part farthest from the middle of the plate.
  • Small, firm movements. A big swipe is what an umpire sees.
  • Keep a little bend in the elbow so there is strength behind the paddle.
  • Chest stays square to the feeder, and the eyes follow the ball into contact.
  • Read the rebound: back toward the middle is right, away from the zone means the paddle met the ball on the wrong side.

Common mistakes

  • Slapping at the ball instead of giving it a firm, controlled tap.
  • Getting the paddle to the inside of the ball, which pushes it farther out of the zone.
  • Standing up or sagging out of the stance during the faster rounds.

Printable drill card

Take this drill to the field: the setup, steps, coaching points and equipment on one card, with the video's address to find it again. Free, no account needed.

Print the drill card

Smaller: half page or quarter page (PDF).

By age

12U

Use tennis balls or soft balls at a slow pace, one location at a time, so the catcher learns where to meet the ball without flinching.

14U and up

Toss firmer, mix the locations, and spend most of the time at the bottom corners, where framing wins the most strikes.

Next: Free defensive lineup generator.

Frequently Asked Questions

What is a framing paddle for catchers?

A flat training glove with no pocket. Because the catcher cannot catch the ball with it, they have to meet it in the right spot, which teaches the hand placement behind good framing.

Can I do the paddle drill without a paddle?

A flat pancake glove works the same way. Without either, the barehand receiving drill teaches some of the same soft, firm contact.

More drills

Start free. Upgrade when your season needs it.

The free plan includes one team and one of each document type, with no license fee and no credit card. Paid plans start at $2.50 a month billed annually, cancel anytime.

See Pricing

No credit card required. Free plan available.